AK47 Receiver Parts

AK47 Front Trunnion

This part holds the barrel to the AK47 receiver and holds the receiver together. It also helps hold the rear sight block. The two lower holes are for rivets through the receiver the hole up top is for the barrel pin

One of the parts on the 922(r) Compliant US parts count list

AK47 Rear Trunnion

This part holds the AK47 receiver together as well as holds the stock in place. The rear AK47 trunnion also has a channel for the recoil assembly which locks into that channel and snaps the receiver cover in place. Pictured is a top view of a typical stamped AK47 receiver rear trunion, the two holes to the left are for the stock screws

One of the parts on the 922(r) Compliant US parts count list

AK47 Bolt Carrier Rails

This rails are placed inside the receiver channel and guide the bolt carrier through it’s range of motion. The rail on the left side also engages the extractor

AK47 Receiver Rivets

These rivets hold the AK47 receiver to the trunions and the trigger guard to the AK47 receiver

Selector Lever Stop

These rivets hold the AK47 receiver to the trunions and the trigger guard to the AK47 receiver

AK47 Trigger guard -Stamped

<< Stamped Receiver AK47 Trigger Guard. ON a milled AK47 receiver they look like this .>>

AK47 Trigger guard – Milled

Magazine Catch

This is the lever that holds & releases the magazine

Magazine Catch Spring

This spring pushes the magazine catch

Magazine Catch Pin

This holds the magazine catch