Partial (80%) AK47 Receivers

Flat w/ Holes – 80% AK47 Receiver

The most common type of partial AK47 to start a build with. Tools & skills are required to correctly bend this type of receiver but it creates the most realistic AK47 when finished. Holes are typically correct if bending was successful and accurate. Dimples vary depending on producer, most flats with holes have dimples of some kind. These need to be heat treated once assembled.

This in not yet an AK47 part. Once it’s bent, rails added, and supports installed it officially becomes an AK47 rifle or AK47 pistol Receiver

Laser Cut – Partial AK47 Receiver
Laser Cut Flat – 80% AK47 Receiver

A flat receiver with all the holes in place. This example has no dimples. and the folds are cut with a laser with small tabs left uncut to keep the parts in place. These flats are bent to shape and a tight weld is run down the edges where typical receivers are folded.

This in not yet an AK47 part. Once it’s bent, rails added, and supports installed it officially becomes an AK47 rifle or AK47 pistol Receiver

Bent Tube – Partial AK47 Receiver

These tubes are for builders who do not want to bend their receiver. These still need to have the rails installed, and holes need to be cut for the pins, magazine, selector switch, etc. Once finished, these need to be heat treated It’s difficult to add the magazine well dimples on this type of receiver.

This in not yet an AK47 part. Once the holes are drilled , rails added, and supports installed it officially becomes an AK47 rifle or AK47 pistol Receiver